| Bore diameter | d | 40 | mm |
| Width | B | 15 | mm |
| Basic static load rating, radial | C0r | 20,300 | |
| Limiting speed | nG | 5,400 |
| Outside diameter | D | 68 | mm |
| Basic dynamic load rating, radial | Cr | 28,000 | |
| Fatigue load limit, radial | Cur | 1,410 |
| Minimum diameter of shaft shoulder | da min | 44,60 | mm |
| Maximum diameter of housing shoulder | Db max | 64,80 | mm |
| Maximum fillet radius of housing | ra1 max | 0,60 | mm |
| Maximum diameter of housing shoulder | Da max | 63,40 | mm |
| Maximum fillet radius of shaft | ra max | 1 | mm |
| Minimum chamfer dimension | rmin | 0,60 | mm |
| Caliber diameter on outer ring wide side face | D2 | 59,40 | mm |
| Shoulder diameter on inner ring wide side face | d1 | 51,90 | mm |
| Distance between the apexes of the pressure cones | a | 30 | mm |
| Shoulder diameter on outer ring wide side face | D1 | 58,80 | mm |
| Caliber diameter on outer ring small side face | D3 | 65 | mm |
| Caliber diameter on inner ring wide side face | d2 | 48,30 | mm |
| Contact angle | α | 40 | ° |
