| Bore diameter | d | 25 | mm |
| Width | B | 15 | mm |
| Basic static load rating, radial | C0r | 9,000 | |
| Limiting speed | nG | 8,000 |
| Outside diameter | D | 52 | mm |
| Basic dynamic load rating, radial | Cr | 16,200 | |
| Fatigue load limit, radial | Cur | 620 | N |
| Minimum diameter of shaft shoulder | da min | 30,60 | mm |
| Maximum diameter of housing shoulder | Db max | 47,80 | mm |
| Maximum fillet radius of housing | ra1 max | 0,60 | mm |
| Maximum diameter of housing shoulder | Da max | 46,40 | mm |
| Maximum fillet radius of shaft | ra max | 1 | mm |
| Minimum chamfer dimension | rmin | 0,60 | mm |
| Caliber diameter on outer ring wide side face | D2 | 44,10 | mm |
| Shoulder diameter on inner ring wide side face | d1 | 35,50 | mm |
| Distance between the apexes of the pressure cones | a | 24 | mm |
| Shoulder diameter on outer ring wide side face | D1 | 42 | mm |
| Caliber diameter on outer ring small side face | D3 | 48 | mm |
| Caliber diameter on inner ring wide side face | d2 | 31,80 | mm |
| Contact angle | α | 40 | ° |
