| Caliber diameter on inner ring wide side face | d2 | 55,60 | mm |
| Contact angle | α | 40 | ° |
| Shoulder diameter on outer ring wide side face | D1 | 71,30 | mm |
| Caliber diameter on outer ring small side face | D3 | 83,30 | mm |
| Distance between the apexes of the pressure cones | a | 39 | mm |
| Minimum chamfer dimension | rmin | 1 | mm |
| Caliber diameter on outer ring wide side face | D2 | 73,90 | mm |
| Shoulder diameter on inner ring wide side face | d1 | 60 | mm |
| Bore diameter | d | 40 | mm |
| Width | B | 23 | mm |
| Basic static load rating, radial | C0r | 34,500 | |
| Limiting speed | nG | 4,650 |
| Outside diameter | D | 90 | mm |
| Basic dynamic load rating, radial | Cr | 57,000 | |
| Fatigue load limit, radial | Cur | 2,390 |
| Minimum diameter of shaft shoulder | da min | 49 | mm |
| Maximum diameter of housing shoulder | Db max | 84,40 | mm |
| Maximum fillet radius of housing | ra1 max | 1 | mm |
| Maximum diameter of housing shoulder | Da max | 81 | mm |
| Maximum fillet radius of shaft | ra max | 1,50 | mm |
