| Ball diameter | dK | 160 | mm |
| Outer eye diameter | d2 | 340 | mm |
| Shank diameter | d4 | 172 | mm |
| Width of the rod end | C1 | 90 | mm |
| Thread length Internal thread | l3 | 135 | mm |
| Distance drilling with/shaft start | l7 | 140 | mm |
| Shank diameter, large | d5 | 217 | mm |
| Radial Clearance | Gr | 0,065 - 0,165 | |
| Bore diameter bearing, lower tolerance | dUT | -0,02 | mm |
| Outer flange diameter inner ring | d1 | 135,60 | mm |
| Thread size | d3 | M130x3 | |
| Shank Length Internal thread head | h1 | 310 | mm |
| Tilt angle | α | 6 | ° |
| Total length internal thread head | l4 | 490 | mm |
| Welding Shank Diameter | d 7 | M24x80 | |
| Edge Spacing | r1smin | 1 | mm |
| Tightening torque | MA | 660 | Nm |
| Width inner ring, lower tolerance | BUT | -0,20 | mm |
| Bore diameter bearing | d | 120 | mm |
| Width inner ring, | B | 85 | mm |
| Basic static load rating, radial | C0r | 2,370,000 |
| Outside diameter bearing | D | 180 | mm |
| Basic dynamic load rating, radial | Cr | 952,000 |
