| C2 | 2,65 | ||
| D | 75 | mm | |
| C1 | 77,30 | H13 |
| D1 | 71 | mm | |
| C | 100 | mm |
| amax | 50 | m/s² | |
| m | 1,14 | kg | |
| Breakaway force (One wiper seal: Multiply by a factor of 0.5.) | 30 | N | |
| Rows of balls | 6 | ||
| Shaft radial clearance h6 (Determined from working bore diameter and shaft tolerance statistics. Recommended housing bore tolerance: H6 or H7. ) | + 30 + 7 |
||
| Permissible ambient temperature (min ... max) (Only unsealed Linear Bushings with steel ball retainers may be used at higher temperatures. Make allowance for reductions in load capacity. ) | -10 °C ... +80 °C |
| vmax | 2 | m/s | |
| FR (One wiper seal: Multiply by a factor of 0.5.,Frictional drags generated by Linear Bushings with integrated wiper seals on two sides when not under radial load. The frictional drags depend on speed and lubrication. ) | 10 | N | |
| m (Friction coefficients of unsealed Linear Bushings when lubricated with oil. The friction coefficient is lowest under heavy load, but can still be above the specified value even under a low load. ) | 0,001 ... 0,004 | ||
| Working bore diameter tolerance | + 19 + 2 |
||
| Operating conditions | Operating conditions |
