Especificaciones
Type (KB) | Standard linear bushings closed, with one wiper seal, R0601 |
---|---|
Series (M) | Standard (metal) |
Shaft diameter (30) | 30 Shaft diameter |
---|---|
Seals (D) | One seal |
D | 47 | mm | |
C1 | 51,70 | H13 | |
D1 | 44,50 | mm |
C | 68 | mm | |
C2 | 1,85 |
amax | 100 | m/s² | |
m | 0,32 | kg | |
Breakaway force (One wiper seal: Multiply by a factor of 0.5.) | 18 | N | |
Rows of balls | 6 | ||
Shaft radial clearance h6 (Determined from working bore diameter and shaft tolerance statistics. Recommended housing bore tolerance: H6 or H7. ) | + 25 + 6 |
||
Permissible ambient temperature (min ... max) (Only unsealed Linear Bushings with steel ball retainers may be used at higher temperatures. Make allowance for reductions in load capacity. ) | -10 °C ... +80 °C |
vmax | 2,50 | m/s | |
FR (One wiper seal: Multiply by a factor of 0.5.,Frictional drags generated by Linear Bushings with integrated wiper seals on two sides when not under radial load. The frictional drags depend on speed and lubrication. ) | 6 | N | |
m (Friction coefficients of unsealed Linear Bushings when lubricated with oil. The friction coefficient is lowest under heavy load, but can still be above the specified value even under a low load. ) | 0,001 ... 0,004 | ||
Working bore diameter tolerance | + 16 + 2 |
||
Operating conditions | Operating conditions |