| C | 68 | mm | |
| C2 | 1,85 | ||
| D | 47 | mm |
| C1 | 51,70 | H13 | |
| D1 | 44,50 | mm |
| amax | 150 | m/s² | |
| m | 0,19 | kg | |
| Breakaway force (One wiper seal: Multiply by a factor of 0.5.) | 6 | N | |
| Rows of balls | 6 | ||
| Shaft radial clearance h6/bore K7 | + 25 - 7 |
||
| Operating conditions | Operating conditions |
| vmax (Speeds of up to 5 m/s possible. Service life is limited by heightened wear to plastic parts. Tests have shown total travel from 50 • 105 m to 100 • 105 m without failure. ) | 3 | m/s | |
| FR (Frictional drags generated by Linear Bushings with integrated wiper seals on two sides when not under radial load. The frictional drags depend on speed and lubrication. ) | 2,50 | N | |
| m (Friction coefficients of unsealed Linear Bushings when lubricated with oil. The friction coefficient is lowest under heavy load, but can still be above the specified value even under a low load. ) | 0,001 ... 0,0025 | ||
| Shaft radial clearance h6/bore H7 | + 43 + 11 |
||
| Shaft radial clearance h6/bore M7 | + 18 - 14 |
||
| Permissible ambient temperature (min ... max) | -10 °C ... +80 °C |
