| D1 | 59 | mm | |
| S1 (Holes at center of dimension C) | 3.5 mm +0.1 | ||
| D | 62 | mm | |
| C1 | 60,30 | H13 |
| K1 | 1,50 | mm | |
| S2 (Holes at center of dimension C) | 3 mm +0.1 | ||
| C | 80 | mm | |
| C2 | 2,15 |
| amax | 150 | m/s² | |
| m | 0,40 | kg | |
| Breakaway force (One wiper seal: Multiply by a factor of 0.5.) | 12 | N | |
| Rows of balls | 7 | ||
| Shaft radial clearance h6/bore K7 | + 29 - 7 |
||
| Operating conditions | Operating conditions |
| vmax | 5 | m/s | |
| FR (One wiper seal: Multiply by a factor of 0.5.,Frictional drags generated by Linear Bushings with integrated wiper seals on two sides when not under radial load. The frictional drags depend on speed and lubrication. ) | 5 | N | |
| m (Friction coefficients of unsealed Linear Bushings when lubricated with oil. The friction coefficient is lowest under heavy load, but can still be above the specified value even under a low load. ) | 0,001 ... 0,004 | ||
| Shaft radial clearance h6/bore H7 | + 50 + 12 |
||
| Shaft radial clearance h6/bore M7 | + 20 - 18 |
||
| Permissible ambient temperature (min ... max) | -20 °C ... +80 °C |
