| K1 | 2,50 | mm | |
| S2 (Holes at center of dimension C) | 5 mm +0.1 | ||
| A | 60 | mm | |
| C1 | 77,30 | H13 | |
| D1 | 72 | mm |
| S1 (Holes at center of dimension C) | 4.5 mm +0.1 | ||
| D | 75 | mm | |
| C | 100 | mm | |
| C2 | 2,65 | ||
| e (Minimum size in relation to shaft Ø d) | 22,10 |
| amax | 150 | m/s² | |
| m | 0,60 | kg | |
| Breakaway force (One wiper seal: Multiply by a factor of 0.5.) | 15 | N | |
| Rows of balls | 6 | ||
| Shaft radial clearance h6/bore K7 | + 29 - 7 |
||
| Operating conditions | Operating conditions |
| vmax | 5 | m/s | |
| FR (One wiper seal: Multiply by a factor of 0.5.,Frictional drags generated by Linear Bushings with integrated wiper seals on two sides when not under radial load. The frictional drags depend on speed and lubrication. ) | 6 | N | |
| m (Friction coefficients of unsealed Linear Bushings when lubricated with oil. The friction coefficient is lowest under heavy load, but can still be above the specified value even under a low load. ) | 0,001 ... 0,004 | ||
| Shaft radial clearance h6/bore H7 | + 50 + 12 |
||
| Shaft radial clearance h6/bore M7 | + 20 - 18 |
||
| Permissible ambient temperature (min ... max) | -20 °C ... +80 °C |
