Especificaciones
Type (LSATE) | Linear sets Adjustable, R1032 |
---|---|
Series (A) | Super a (with misalignment compensation) |
Shaft diameter (12) | 12 Shaft diameter |
---|---|
Seals (DD) | With two seals |
a)
Lubricating hole M8 x 1 sealed with plastic cap
S2 (Fixing screws ISO 4762-8.8) | 4,30 | ||
SW | 2,50 | ||
D | 22 | mm | |
E3 | 56 mm ±0.15 | ||
E5 | 24 | ||
H | 18 | mm | |
H1 | 35 | mm | |
H4 | 10 | mm | |
m (Clamped (fastened) in relation to Ø d.) | 21.5 mm ±0.01 | ||
N3 | 11 | mm |
S4 (Pin hole centering.) | 4 | mm | |
V | 5 | mm | |
B1 | 43 | mm | |
E4 | 32 mm ±0.15 | ||
E6 | 34 | mm | |
Tolerance for H (Clamped (fastened) in relation to Ø d.) | + 8 - 16 |
||
H3 | 10 | mm | |
L | 76 | mm | |
N2 | 16,50 | mm | |
S3 | M5 |
amax | 150 | m/s² | |
m | 0,27 | kg | |
Breakaway force | 1,50 | N | |
Operating conditions | Operating conditions |
vmax (Speeds of up to 5 m/s possible. Service life is limited by heightened wear to plastic parts. Tests have shown total travel from 50 • 105 m to 100 • 105 m without failure. ) | 3 | m/s | |
FR (Frictional drags generated by Linear Bushings with integrated wiper seals on two sides when not under radial load. The frictional drags depend on speed and lubrication. ) | 0,80 | N | |
Radial clearance | Comes clamped to h5 shaft (lower limit) and set to zero clearance | ||
Permissible ambient temperature (min ... max) | -10 °C ... +80 °C |