a)
Lubricating hole M8 x 1 sealed with plastic cap
| S3 | M12 | ||
| V | 10 | mm | |
| D | 62 | mm | |
| B1 | 108 | mm | |
| E4 | 86 mm ±0.15 | ||
| E6 | 90 | mm | |
| Tolerance for H (Clamped (fastened) in relation to Ø d.) | + 8 - 16 |
||
| H3 | 20 | mm | |
| L | 176 | mm | |
| N2 | 44 | mm | |
| S2 (Fixing screws ISO 4762-8.8) | 10,50 |
| SW | 4 | ||
| W (Minimum size in relation to Ø d.) | 19,50 | mm | |
| A | 56 | mm | |
| E3 | 124 mm ±0.15 | ||
| E5 | 60 | ||
| H | 45 | mm | |
| H2 | 77 | mm | |
| H4 | 6 | mm | |
| m (Clamped (fastened) in relation to Ø d.) | 54 mm ±0.01 | ||
| N3 | 26 | mm | |
| S4 (Pin hole centering.) | 8 | mm |
| amax | 150 | m/s² | |
| m | 3,15 | kg | |
| Breakaway force | 8 | N | |
| Operating conditions | Operating conditions |
| vmax (Speeds of up to 5 m/s possible. Service life is limited by heightened wear to plastic parts. Tests have shown total travel from 50 • 105 m to 100 • 105 m without failure. ) | 3 | m/s | |
| FR (Frictional drags generated by Linear Bushings with integrated wiper seals on two sides when not under radial load. The frictional drags depend on speed and lubrication. ) | 3 | N | |
| Radial clearance | Comes clamped to h5 shaft (lower limit) and set to zero clearance | ||
| Permissible ambient temperature (min ... max) | -10 °C ... +80 °C |
