Especificaciones
Type (LSA) | Linear sets Closed, R1035 |
---|---|
Series (B) | Super b (no misalignment compensation) |
Shaft diameter (30) | 30 Shaft diameter |
---|---|
Seals (DD) | With two seals |
a)
Lubricating hole sealed with plastic cap
S (Fixing screws ISO 4762-8.8) | 8,40 | ||
SW | 5 | ||
D | 47 | mm | |
E1 | 68 mm ±0.15 | ||
E3 | 72 | mm | |
H | 35 | mm | |
H1 | 70 | mm | |
H4 | 22 | mm | |
l3 | 16 | ||
N1 | 34 | mm | |
S1 | M10 |
S2 (Pin hole centering.) | 6 | ||
V | 8 | mm | |
A | 87 | mm | |
E2 | 45 mm ±0.15 | ||
E4 | 30 | mm | |
Tolerance for H (Clamped (fastened) in relation to Ø d.) | + 8 - 16 |
||
H3 | 11,50 | mm | |
L | 79 | mm | |
m (Clamped (fastened) in relation to Ø d.) | 43.5 mm ±0.01 | ||
N2 | 22 | mm |
amax | 150 | m/s² | |
m | 0,97 | kg | |
Breakaway force | 6 | N | |
Operating conditions | Operating conditions |
vmax (Speeds of up to 5 m/s possible. Service life is limited by heightened wear to plastic parts. Tests have shown total travel from 50 • 105 m to 100 • 105 m without failure. ) | 3 | m/s | |
FR (Frictional drags generated by Linear Bushings with integrated wiper seals on two sides when not under radial load. The frictional drags depend on speed and lubrication. ) | 2,50 | N | |
Shaft radial clearance h6 | + 43 + 11 |
||
Permissible ambient temperature (min ... max) | -10 °C ... +80 °C |