Especificaciones
Lubricación | No initial lubrication |
---|
Peso | 100g |
---|
a)
Lubricating hole sealed with plastic cap
D | 19 | mm | |
E1 | 29 mm ±0.15 | ||
E3 | 31 | mm | |
H | 16 | mm | |
H1 | 31,50 | mm | |
H4 | 10 | mm | |
l3 | 10,50 | ||
N1 | 15 | mm | |
S (Fixing screws ISO 4762-8.8) | 4,30 | ||
S2 (Pin hole centering.) | 4 | ||
V | 5 | mm |
A | 40 | mm | |
E2 | 20 mm ±0.15 | ||
E4 | 29 | mm | |
Tolerance for H (Clamped (fastened) in relation to Ø d.) | + 8 - 16 |
||
H3 | 10 | mm | |
L | 36 | mm | |
m (Clamped (fastened) in relation to Ø d.) | 20 mm ±0.01 | ||
N2 | 11 | mm | |
S1 | M5 | ||
SW | 2,50 |
amax | 150 | m/s² | |
m | 0,10 | kg | |
Breakaway force | 1 | N | |
Operating conditions | Operating conditions |
vmax (Speeds of up to 5 m/s possible. Service life is limited by heightened wear to plastic parts. Tests have shown total travel from 50 • 105 m to 100 • 105 m without failure. ) | 3 | m/s | |
FR (Frictional drags generated by Linear Bushings with integrated wiper seals on two sides when not under radial load. The frictional drags depend on speed and lubrication. ) | 0,50 | N | |
Radial clearance | Comes clamped to h5 shaft (lower limit) and set to zero clearance | ||
Permissible ambient temperature (min ... max) | -10 °C ... +80 °C |
Stock | Pedir cotización |
---|---|
Referencia | R103681020 |
Fabricante | REXROTH |
Unidades | Precio / Unidad |
---|---|
1+ | $83,04 |