Especificaciones
Type (LSAOE) | Linear sets Open, R1038 |
---|---|
Series (A) | Super a (with misalignment compensation) |
Shaft diameter (20) | 20 Shaft diameter |
---|---|
Seals (DD) | With two seals |
a)
Lubricating hole sealed with plastic cap
S1 | M8 | ||
A | 55 | mm | |
E1 | 45 mm ±0.15 | ||
E3 | 50 | mm | |
H | 25 | mm | |
H1 | 42 | mm | |
H4 | 3,50 | mm | |
l3 | 13,50 | ||
N1 | 24 | mm | |
S (Fixing screws ISO 4762-8.8) | 6,60 | ||
V | 5 | mm | |
S2 (Pin hole centering.) | 5 |
D | 32 | mm | |
A | 60 | mm | |
E2 | 32 mm ±0.15 | ||
E4 | 45 | mm | |
Tolerance for H (Clamped (fastened) in relation to Ø d.) | + 8 - 16 |
||
H3 | 10 | mm | |
L | 54 | mm | |
m (Clamped (fastened) in relation to Ø d.) | 30 mm ±0.01 | ||
N2 | 18 | mm | |
SW | 2,50 | ||
W (Minimum size in relation to Ø d.) | 9 | mm |
amax | 150 | m/s² | |
m | 0,30 | kg | |
Breakaway force | 3 | N | |
Operating conditions | Operating conditions |
vmax (Speeds of up to 5 m/s possible. Service life is limited by heightened wear to plastic parts. Tests have shown total travel from 50 • 105 m to 100 • 105 m without failure. ) | 3 | m/s | |
FR (Frictional drags generated by Linear Bushings with integrated wiper seals on two sides when not under radial load. The frictional drags depend on speed and lubrication. ) | 1,50 | N | |
Radial clearance | Comes clamped to h5 shaft (lower limit) and set to zero clearance | ||
Permissible ambient temperature (min ... max) | -10 °C ... +80 °C |
Stock | 23 uds. |
---|---|
Referencia | R103862020 |
Fabricante | Rexroth |
Unidades | Precio / Unidad |
---|---|
1 - 4 | $138,79 |
5 - 9 | $136,02 |
10 - 14 | $133,24 |
15+ | $130,46 |