| S | 9 | ||
| V (Tolerance ISO 8062-3 - DCTG 9.) | 14 | mm | |
| A (Tolerance ISO 8062-3 - DCTG 9.) | 130 | mm | |
| B (Tolerance ISO 8062-3 - DCTG 9.) | 70 | ||
| E1 | 108 mm ±0.2 | ||
| H | 50 | mm | |
| H1 (Tolerance ISO 8062-3 - DCTG 9.) | 105 | mm |
| SW | 8 | ||
| D | 75 | mm | |
| A1 (Tolerance ISO 8062-3 - DCTG 9.) | 57 | mm | |
| B1 | 72 | mm | |
| E2 | 50 mm ±0.2 | ||
| Tolerance for H (Clamped (fastened) in relation to Ø d.) | + 13 - 21 |
||
| L | 100 | mm |
| amax | 150 | m/s² | |
| m | 3,15 | kg | |
| Breakaway force | 10 | N | |
| Operating conditions | Operating conditions |
| vmax (Speeds of up to 5 m/s possible. Service life is limited by heightened wear to plastic parts. Tests have shown total travel from 50 • 105 m to 100 • 105 m without failure. ) | 3 | m/s | |
| FR (Frictional drags generated by Linear Bushings with integrated wiper seals on two sides when not under radial load. The frictional drags depend on speed and lubrication. ) | 4 | N | |
| Radial clearance | Comes clamped to h5 shaft (lower limit) and set to zero clearance | ||
| Permissible ambient temperature (min ... max) | -10 °C ... +80 °C |
