Especificaciones
Lubricación | No initial lubrication |
---|
Peso | 200g |
---|
D | 26 | mm | |
A (Tolerance ISO 8062-3 - DCTG 9.) | 50 | mm | |
B1 | 22 | mm | |
E2 | 26 mm ±0.15 | ||
Tolerance for H (Clamped (fastened) in relation to Ø d.) | + 8 - 16 |
||
L | 36 | mm | |
SW | 2,50 | ||
W (Minimum size in relation to Ø d.) | 9 | mm |
A | 68 | mm | |
B (Tolerance ISO 8062-3 - DCTG 9.) | 35 | ||
E1 | 40 mm ±0.15 | ||
H | 22 | mm | |
H2 (Tolerance ISO 8062-3 - DCTG 9.) | 35 | mm | |
S | 4,50 | ||
V (Tolerance ISO 8062-3 - DCTG 9.) | 6,50 | mm |
amax | 150 | m/s² | |
m | 0,20 | kg | |
Breakaway force | 2 | N | |
Operating conditions | Operating conditions |
vmax (Speeds of up to 5 m/s possible. Service life is limited by heightened wear to plastic parts. Tests have shown total travel from 50 • 105 m to 100 • 105 m without failure. ) | 3 | m/s | |
FR (Frictional drags generated by Linear Bushings with integrated wiper seals on two sides when not under radial load. The frictional drags depend on speed and lubrication. ) | 1 | N | |
Shaft radial clearance h6 | + 28 + 1 |
||
Permissible ambient temperature (min ... max) | -10 °C ... +80 °C |