a)
Lubricating hole sealed with plastic cap
b)
Maximum acceptable loads:
| SW2 | 5 | ||
| V1 | 11 | mm | |
| D | 60 | mm | |
| A1 | 83 | mm | |
| E2 | 110 | mm | |
| E4 | 65 | mm | |
| Tolerance for H (Clamped (fastened) based on nominal shaft dimension d.) | + 15 - 5 |
||
| H2 | 30 | mm | |
| L1 | 84 mm +0.5 | ||
| S | 13,50 |
| V | 18 | mm | |
| W (Minimum size in relation to shaft diameter d.) | 14 | mm | |
| A | 110 | mm | |
| A2 | 27 | mm | |
| E3 | 28 | mm | |
| H | 48 | mm | |
| H1 | 118 | mm | |
| L | 140 | mm | |
| O (DIN 6912-8.8 cylinder head bolts, recommendation applies for bolting in steel or cast iron threads. ) | M12x30 | ||
| SW1 | 17 |
| amax | 50 | m/s² | |
| m | 7,80 | kg | |
| Breakaway force | 24 | N | |
| Operating conditions | Operating conditions |
| vmax | 2 | m/s | |
| FR | 8 | N | |
| Radial clearance | Comes with an h5 shaft (lower limit) and set to zero clearance | ||
| Permissible ambient temperature (min ... max) (100 °C for a short period) | -20 °C ... +80 °C |
