a)
Lubricating hole M8 x 1 sealed with plastic cap
| S (Fixing screws DIN 6912-8.8.) | 13,50 | ||
| W (Minimum size in relation to Ø d.) | 22,50 | mm | |
| N | 34 | mm | |
| D | 75 | mm | |
| B | 130 | ||
| E2 | 100 mm ±0.2 | ||
| Tolerance for H (Clamped (fastened) in relation to Ø d.) | + 8 - 16 |
||
| H3 | 10 | mm |
| S1 | M16 | ||
| L | 224 | mm | |
| N1 | 77 | mm | |
| A | 54 | mm | |
| E1 | 125 mm ±0.2 | ||
| H | 50 | mm | |
| H2 | 88 | mm |
| amax | 150 | m/s² | |
| m | 5,50 | kg | |
| Breakaway force | 10 | N | |
| Operating conditions | Operating conditions |
| vmax (Speeds of up to 5 m/s possible. Service life is limited by heightened wear to plastic parts. Tests have shown total travel from 50 • 105 m to 100 • 105 m without failure. ) | 3 | m/s | |
| FR (Frictional drags generated by Linear Bushings with integrated wiper seals on two sides when not under radial load. The frictional drags depend on speed and lubrication. ) | 4 | N | |
| Shaft radial clearance h6 (Clamped (fastened).) | + 35 - 3 |
||
| Permissible ambient temperature (min ... max) | -10 °C ... +80 °C |
