a)
Lubricating hole sealed with plastic cap
M8x1 (Ø d 20 – 50 mm)
M10x1 (Ø d = 60 mm)
| S2 | 8 | ||
| V | 10 | mm | |
| A | 108 | mm | |
| E2 | 58 mm ±0.15 | ||
| E4 | 25 | mm | |
| Tolerance for H (Clamped (fastened) in relation to Ø d.) | + 8 - 16 |
||
| H4 | 28 | mm | |
| m | 54 mm ±0.01 | ||
| N2 | 26 | mm | |
| S1 | M12 |
| SW | 6 | ||
| D | 62 | mm | |
| E1 | 86 mm ±0.15 | ||
| E3 | 90 | mm | |
| H | 45 | mm | |
| H1 | 90 | mm | |
| L | 81 | mm | |
| N1 | 44 | mm | |
| S | 10,50 |
| amax | 150 | m/s² | |
| m | 1,63 | kg | |
| Breakaway force | 12 | N | |
| Operating conditions | Operating conditions |
| vmax | 5 | m/s | |
| FR (Frictional drags generated by Linear Bushings with integrated wiper seals on two sides when not under radial load. The frictional drags depend on speed and lubrication. ) | 5 | N | |
| Shaft radial clearance h6 (Clamped (fastened).) | + 50 + 12 |
||
| Permissible ambient temperature (min ... max) | -20 °C ... +80 °C |
