a)
Lubricating hole sealed with plastic cap
| S1 | M20 | ||
| V | 13 | mm | |
| D | 90 | mm | |
| A | 164 | mm | |
| E2 | 65 mm ±0.2 | ||
| E4 | 108 | mm | |
| Tolerance for H (Clamped (fastened) in relation to Ø d.) | + 8 - 16 |
||
| H3 | 15 | mm | |
| L | 126 | mm | |
| m (Clamped (fastened) in relation to Ø d.) | 82 mm ±0.01 | ||
| N2 | 42 | mm | |
| S2 | 12 |
| SW | 6 | ||
| W | 27 | mm | |
| A | 55 | mm | |
| E1 | 132 mm ±0.2 | ||
| E3 | 132 | mm | |
| H | 60 | mm | |
| H1 | 105 | mm | |
| H4 | 5 | mm | |
| l3 | 50 | ||
| N1 | 59 | mm | |
| S | 17,50 |
| amax | 150 | m/s² | |
| m | 4,40 | kg | |
| Breakaway force | 27 | N | |
| Operating conditions | Operating conditions |
| vmax | 5 | m/s | |
| FR (Frictional drags generated by Linear Bushings with integrated wiper seals on two sides when not under radial load. The frictional drags depend on speed and lubrication. ) | 10,50 | N | |
| Shaft radial clearance h6 (Clamped (fastened).) | + 39 - 4 |
||
| Permissible ambient temperature (min ... max) | -20 °C ... +80 °C |
