a)
For O-ring: Size 25: Ø 5 · 1.5 (mm). Open the lube port if required. Please request instructions. For new designs, use the runner blocks for lubrication from above.
b)
Recommended position for pin holes (see general technical notes and information in the "Maintenance" section). Pre-drilled holes may be present at this position for manufacturing reasons. They are suitable for drilling out.
c)
Lube nipple, thread M6 – 8 deep: Connection is only possible on end-face. Dimensions differ among different connection pieces. See "Accessories" for more information about lube fittings.
d)
For guide rails of accuracy class H, this base area may be without a slot for manufacturing reasons.
| V1 | 7.5 | ||
| A1 | 24 | ||
| A3 | 12.5 | ||
| B1 | 63.5 | ||
| B3 | 97 | ||
| d8.2 | 5 | ||
| E2 | 35 | ||
| E8.2 | 40.22 | ||
| E9.2 | 25.4 | ||
| H1 | 34 | ||
| Dimension H2 without cover strip | 23.4 | ||
| N3 | 9 | ||
| N6 | 14.3 mm ±0.5 | ||
| ØS5 | 7 | ||
| T2 | 30 |
| A | 48 | ||
| A2 | 23 | ||
| B | 91 | ||
| B2 | 93 | ||
| d8 | 6 | ||
| E1 | 35 | ||
| E8 | 33.4 | ||
| E9 | 12.4 | ||
| H | 40 | ||
| Dimension H2 with cover strip | 23.6 | ||
| K1 | 19.1 | ||
| N5 | 9.5 | ||
| S2 | M6 | ||
| S9 | M3 ‒ 5 mm deep |
| amax | 150 | ||
| m | 0.6 | ||
| μ | 0.0004 ... 0.001 | ||
| Operating conditions | Operating conditions |
| vmax | 3 | ||
| FR | 30 | ||
| Material | CS | ||
| Permissible ambient temperature (min ... max) | -10 °C ... +80 °C |
