a)
For O-ring
size 55/85: Ø 7 · 1.5 (mm)
size 65/100: Ø 12 · 1.5 (mm)
Open lube port if necessary (see section entitled "Lubrication").
b)
Recommended position for pin holes
(E4 dimensions, see section entitled "Notes for mounting", segment "Pinned fitting").
Rough-drilled holes made for may exist at this position for manufacturing reasons. They are suitable for drilling out.
c)
Lube nipple, thread M6 – 8 deep:
Connection possible on all sides.
Dimensions differ among different connection pieces. See "Accessories" for more information about lube ports.
| A | 200 | mm | |
| A2 | 100 | mm | |
| A3.1 | 50 | mm | |
| B1 | 194 | mm | |
| B3 | 264 | mm | |
| E2 | 110 | mm | |
| E8 | 72 | mm | |
| E9 | 19,30 | mm | |
| H | 100 | mm | |
| Dimension H2 with cover strip | 58,15 | mm | |
| K2 | 59 | mm | |
| N5 | 27 | mm | |
| N6 | 39 mm ±0.5 | ||
| ØS5 | 16 | mm | |
| T3 | 38 | mm |
| A1 | 100 | mm | |
| A3 | 50 | mm | |
| B | 254 | ||
| B2 | 258 | mm | |
| E1 | 172 | mm | |
| E3 | 50 | mm | |
| E8.2 | 143 | mm | |
| E9.2 | 65 | mm | |
| H1 | 86 | mm | |
| K1 | 55 | mm | |
| N3 | 20 | mm | |
| N5.1 | 19,30 | mm | |
| S2 | M14 | ||
| T (Dimension T = Division of the Roller Guide Rail) | 75 | mm | |
| V1 | 15 | mm |
| C | 265.500 | N | |
| Mt | 14.300 | Nm | |
| ML | 7.960 | Nm |
| C0 | 525.600 | N | |
| Mt0 | 28.350 | Nm | |
| ML0 | 15.760 | Nm |
