| Minimum chamfer dimension | rmin | 0,60 | mm |
| Distance between rolling elements | X | 100 | mm |
| Distance ring grooves | C1 | 107,20 | mm |
| Width of groove | m/2 | 5,20 | mm |
| Chamfer width | C2 | 2 | mm |
| Width, outer ring | C | 121 | mm |
| Diameter of groove | D1 | 254 | mm |
| Bore diameter | d | 170 | mm |
| Width | B | 122 | mm |
| Basic static load rating, radial | C0r | 1,750,000 | |
| Limiting speed for grease lubrication | nG Grease | 740 | 1/min |
| Outside diameter | D | 260 | mm |
| Basic dynamic load rating, radial | Cr | 960,000 | |
| Fatigue load limit, radial | Cur | 224,000 |
| Mounting dim for snap ring WRE (not included in delivery) Tolerance: 0/-0,2 | Ca1 | 99 | mm |
| Rib diameter inner ring | d1 | 201 | mm |
| Outside diameter of snap ring WRE | d3 | 282 | mm |
| Maximum recess radius | ra max | 0,60 | mm |
| Lower distance snap ring tolerance | -0,20 | mm | |
| Upper distance ring groove tolerance | 0,20 | mm |
| Mounting dim for retaining ring to DIN 471 (not incl. In delivery) Tol: 0/-0,2 | Ca2 | 97 | mm |
| Sealing diameter (rib) | d2 | 220 | mm |
| Minimum diameter shaft shoulder | da min | 201 | mm |
| Chamfer angle | 30 | ° | |
| Lower distance retaining ring tolerance | -0,20 | mm |
