| Maximum diameter of housing shoulder | Da max | 43 | mm |
| Minimum diameter shaft shoulder | da min | 28 | mm |
| Outside diameter | D | 68 | mm |
| Basic dynamic load rating, axial | Ca | 33,500 | |
| Basic dynamic load rating, radial | Cr | 14,900 | |
| Fatigue load limit, axial | Cua | 6,400 | |
| Limiting speed for oil lubrication | nG Oil | 7,000 | |
| Bearing friction torque | MRL | 0,37 | Nm |
| Height | T | 60 | mm |
| Basic static load rating, axial | C0a | 76,000 | |
| Basic static load rating, radial | C0r | 22,400 | |
| Fatigue load limit, radial | Cur | 3,400 | |
| Limiting speed for grease lubrication | nG Grease | 2,000 | |
| Bore diameter | d | 20 | mm |
| Height outer ring over wave washer | H1 | 43 | mm |
| Distance to lubrication hole | Ca | 8 | mm |
| Heeldiameter wave washer long | D2 | 30 | mm |
| Width, wave washer | B | 10 | mm |
| Width heel wave washer long | B2 | 12 | mm |
| Minimum chamfer dimension 1 | r1 min | 0,60 | mm |
| Pitch circle diameter (holes) | J | 53 | mm |
| Split | n x t | 45 | ° |
| Width, outer ring | C | 14 | mm |
| Rip diameter shaft washer | d1 | 42 | mm |
| Outside diameter wave washer long | D3 | 40 | mm |
| Width wave washer long | B1 | 24 | mm |
| Minimum chamfer dimension | rmin | 0,30 | mm |
| Diameter lubrication hole | ds | 3,20 | mm |
| Number (screwing holes) | n | 8 |
