| Maximum diameter of housing shoulder | Da max | 74 | mm |
| Minimum diameter shaft shoulder | da min | 58 | mm |
| Outside diameter | D | 110 | mm |
| Basic dynamic load rating, axial | Ca | 105,000 | |
| Basic dynamic load rating, radial | Cr | 27,500 | |
| Fatigue load limit, axial | Cua | 22,900 | |
| Limiting speed for oil lubrication | nG Oil | 4,000 | |
| Bearing friction torque | MRL | 1,70 | Nm |
| Height | T | 82 | mm |
| Basic static load rating, axial | C0a | 265,000 | |
| Basic static load rating, radial | C0r | 53,000 | |
| Fatigue load limit, radial | Cur | 7,600 | |
| Limiting speed for grease lubrication | nG Grease | 1,250 | |
| Bore diameter | d | 35 | mm |
| Height outer ring over wave washer | H1 | 57 | mm |
| Distance to lubrication hole | Ca | 10 | mm |
| Heeldiameter wave washer long | D2 | 60 | mm |
| Width, wave washer | B | 14 | mm |
| Width heel wave washer long | B2 | 13 | mm |
| Minimum chamfer dimension 1 | r1 min | 0,60 | mm |
| Pitch circle diameter (holes) | J | 88 | mm |
| Split | n x t | 30 | ° |
| Width, outer ring | C | 18 | mm |
| Rip diameter shaft washer | d1 | 73 | mm |
| Outside diameter wave washer long | D3 | 73 | mm |
| Width wave washer long | B1 | 30 | mm |
| Minimum chamfer dimension | rmin | 0,30 | mm |
| Diameter lubrication hole | ds | 3,20 | mm |
| Number (screwing holes) | n | 12 |
| Fabricante | Referencia |
|---|---|
| Unitec | SRB35110FL |
| APB | AXZF35110-X-L-TVPB |
| Nadella | ARNBT 35 110/1 |
