Pitch circle diameter fixing holes in outer ring | J1 | 225 | mm |
Fixing holes diameter inner ring | d1 | 7 | mm |
Counterbore depth of fixing holes | a | 6,20 | mm |
Fixing holes diameter outer ring | d3 | 7 | mm |
Pitch quantity | n | 36 | |
Threaded extraction hole | G | M8 | |
Screw tightening torque | MA | 10,32 | Nm |
Pitch circle diameter fixing holes in inner ring | J | 165 | mm |
Counterbore diameter of fixing holes | d2 | 11 | mm |
Quantity of fixing holes inner ring | 34 | ||
Quantity of fixing holes outer ring | 33 | ||
Pitch separation angle | t | 10 | ° |
Quantity of threaded extraction hole | 3 | ||
Quantity of retaining screws | 2 |
Bore diameter lower tolerance | -0,01 | mm | |
Flange diameter lower tolerance | -0,02 | mm | |
Limiting speed | nG | 3,600 | |
Basic static load rating, axial | C0a | 380,000 | |
Bore diameter | d | 150 | mm |
Flange diameter | D | 240 | mm |
Height | T | 40 | mm |
Basic dynamic load rating, axial | Ca | 81,000 | |
Fatigue load limit, axial | Cua | 12,600 |
Height contact face outer ring | H1 | 26 | mm |
Height contact face outerring H1 lower tolerance | -0,18 | mm | |
Rib diameter inner ring | d1 | 188 | mm |
Axial and radial runout, measurement standard; Measured on mounted bearing, with ideal adjacent construction. | t1 | 3 | µm |
Height contact face outerring H1 upper tolerance | 0,18 | mm | |
Outside diameter D1 | D1 | 214 | mm |
Outside diameter D3 | D3 | 211 | mm |
Fabricante | Referencia |
---|---|
S4M | SEL/D150 |
Stock | Pedir cotización |
---|---|
Referencia | ZKLDF150 |
Fabricante | INA |
Unidades | Precio / Unidad |
---|---|
1+ | $5.745,02 |