| Pitch circle diameter fixing holes in outer ring | J1 | 580 | mm |
| Fixing holes diameter inner ring | d1 | 9,30 | mm |
| Counterbore depth of fixing holes | a | 8,20 | mm |
| Fixing holes diameter outer ring | d3 | 9,30 | mm |
| Pitch quantity | n | 48 | |
| Threaded extraction hole | G | M12 | |
| Screw tightening torque | MA | 25,07 | Nm |
| Pitch circle diameter fixing holes in inner ring | J | 482 | mm |
| Counterbore diameter of fixing holes | d2 | 15 | mm |
| Quantity of fixing holes inner ring | 46 | ||
| Quantity of fixing holes outer ring | 45 | ||
| Pitch separation angle | t | 7,50 | ° |
| Quantity of threaded extraction hole | 3 | ||
| Quantity of retaining screws | 2 |
| Bore diameter lower tolerance | -0,02 | mm | |
| Flange diameter lower tolerance | -0,03 | mm | |
| Limiting speed | nG | 1,400 | |
| Basic static load rating, axial | C0a | 1,860,000 | |
| Bore diameter | d | 460 | mm |
| Flange diameter | D | 600 | mm |
| Height | T | 70 | mm |
| Basic dynamic load rating, axial | Ca | 255,000 | |
| Fatigue load limit, axial | Cua | 37,000 |
| Height contact face outer ring | H1 | 46 | mm |
| Height contact face outerring H1 lower tolerance | -0,23 | mm | |
| Rib diameter inner ring | d1 | 520 | mm |
| Axial and radial runout, measurement standard; Measured on mounted bearing, with ideal adjacent construction. | t1 | 6 | µm |
| Height contact face outerring H1 upper tolerance | 0,23 | mm | |
| Outside diameter D1 | D1 | 560 | mm |
| Outside diameter D3 | D3 | 563 | mm |
| Fabricante | Referencia |
|---|---|
| S4M | SEL/D460 |
